2S-6S EC5 Charger Interface Panel Set

SKU: AC-CIP6E5B
  • Panel-mount board to relocate charger connections

Price as configured: $0.00

Product Options

1 x 2S-6S EC5 Charger Interface Panel   (Excellent Stock)   +$9.99
1 x Banana Plug Binding Post for PRC Cases   (Excellent Stock)   +$5.00
1 x 90 Degree Power Supply to Banana Plug Binding Post Cable   (Good Stock)   +$6.00

Description

Details

This 2S-6S JST-XH EC5 Charger Interface Panel (or CIP) provides a set of balance connectors, a EC5 connector, and room for a set of banana plugs (included). This product is made to be mounted underneath or on top of many surfaces and panels, such as our ProgressiveRC Case decks, and provides a full relocation of the charger outputs with a full balance board as well as a connector for your EC5 batteries, ready to go to charge any single pack with a EC5 connector, or use any standard charge cable for any other connector. You can also use this to connect any parallel boards or cables when charging one battery just isn't enough! Connects directly to your charger with charge connectors rated for 40A, This product provides a compact and elegant solution to mounted charger connections.

Installation Note: Remove and do not use upper plastic spacer on banana plug binding posts. Use only the lower plastic spacer above the circuit board.

Reviews

Customer Reviews (1)

EC5 interfaceReview by william
Value
Service
Quality
i installed this on a nomad case deck to use with a powerlab 6. works great. switching from battery to battery i only need to put in the charge and balance plug needed for each.
dont forgot that if your going to use this to install into a deck that there is a template "DXF Template for Charger Interface Panel cutout" under the manual tab for this item. that was very helpful for my install. (Posted on 11/11/2016)

Write Your Own Review

You're reviewing: 2S-6S EC5 Charger Interface Panel Set

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Service
Quality
Value

Manual