2S-6S Charger Interface Panel Set

Panel-mount board to relocate charger connections
Ships today if ordered in the next

Price as configured: $0.00

Product Options

1 x Banana Plug Binding Post for PRC Cases   (Excellent Stock)   +$5.00



This 2S-6S JST-XH Charger Interface Panel (or CIP) provides a set of balance connectors, an EC5 or XT60 connector, and room for a set of banana plugs (included). This product is made to be mounted underneath or on top of many surfaces and panels, such as our ProgressiveRC Case decks, and provides a full relocation of the charger outputs with a full balance board as well as a connector for your EC5 batteries, ready to go to charge any single pack with an EC5 or XT60 connector, or use any standard charge cable for any other connector. You can also use this to connect any parallel boards or cables when charging one battery just isn't enough! Connects directly to your charger with charge connectors rated for 40A, This product provides a compact and elegant solution to mounted charger connections.

Installation Note: Ensure both plastic spacers of the banana plug binding posts are above the circuit board - do not use a spacer below the board.


Customer Reviews (1)

EC5 interfaceReview by william
i installed this on a nomad case deck to use with a powerlab 6. works great. switching from battery to battery i only need to put in the charge and balance plug needed for each.
dont forgot that if your going to use this to install into a deck that there is a template "DXF Template for Charger Interface Panel cutout" under the manual tab for this item. that was very helpful for my install. (Posted on 11/11/2016)

Write Your Own Review

You're reviewing: 2S-6S Charger Interface Panel Set

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars