BetaFPV BT2.0 1S LiHV Charger

Charge your BT2.0 batteries with this six-channel charger!

6 available




It may not look like it, but this compact little board is actually a six-channel charger!

Designed specifically for the new BT2.0 connector, the board is capable of charging up to six cells at a time - the six ports are fully independent of one another, rather than in parallel so you can add and take off batteries at any time without worrying about their respective voltages. The charge rate is fixed at 400mA, which is a safe level for just about any 1S that you're likely to be using. The simple LED indicators make the status of each battery obvious: red is charging, green is done!

It's easy to power the board from any 3S or 4S LiPo with an XT60 connector - the input voltage selector will ensure that you don't drain your LiPo too far. The cutoff voltage is set to 10.8V for 3S, and 14.4V for 4S, and the digital readout will give you a constant readout of your input voltage.



Maximum Charge Power 11W
Charge Current Range 400mA
Input Voltage 3S-4S LiPo
LiPo/LiIo/LiFe 1S LiHV
Dimensions 75x42x22mm
Weight 36.86g


Write Your Own Review

You're reviewing: BetaFPV BT2.0 1S LiHV Charger

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars