Lumenier 4Power Quick Swap Power Distribution Board

SKU: PB-LQS
Innovative PDB lets you swap out ESCs in seconds with no soldering
Ships today if ordered in the next
Hours
:
Mins
:
Secs

1 available

$19.99

Description

Details

The Quick Swap PDB enables solder-less arm connections with ESC power being routed into specially designed power taps and the ESC Servo connection being made available on the side underneath the power connection. This enables you to detach both ESC power and Servo connections in seconds without the need of a soldering iron or to take your airframe apart.

The Quick Swap board is compatible with any ESC and does not require any special connectors to be fitted to the ESCs, just bare power wires is all that's needed - although 2mm bullet connectors are a perfect fit as well. The Quick Swap board uses the standard mounting holes used by most flight controllers of 30.5mm. This board makes servicing of airframes such as the QAV-R a breeze. Carry a few pre-built arms and downtime from a damaged motor or burned out ESC is minimized significantly. The included right angle pin headers can be soldered directly to the PDB. There are solder pads adjacent to the pin header holes enabling you to use short wire to jump the ground/signal wire to your flight controller. By implementing this feature your ESC signal cable can be hot swapped without the need for desoldering from the FC.

Specifications

Specifications

Dimensions 50x36x8mm
Weight 13g

Reviews

Customer Reviews (1)

GoodReview by Rung
Quality
Value
Service
Good (Posted on 9/3/2016)

Write Your Own Review

You're reviewing: Lumenier 4Power Quick Swap Power Distribution Board

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Value
Service
Quality