Ethix Mr Steele Stout Motor V3

SKU: MT-ET-2306-1750
The perfect motor for 6S freestyle flight!

36 available




Introducing the third iteration of the Mr Steele motor line. This well-refined piece of kit is built upon the success of its predecessors and tuned for an even higher flight envelope. The same beloved 2306 stator is in play but this time with a beefier and much smoother 9mm ball bearing (up 2mm from the previous 7mm). This allows for a thicker overall shaft adding substantial durability and more material to dissipate heat built up from consistent power-hungry abusive rippers.

This motor is also offered in a slightly higher KV for its 6S variant: 50KV up from the V2 1700KV Stout. The increase in KV adds just enough more power without dipping into the red zone of diminishing returns on efficiency. So, it's just as efficient but with more pop.

Featuring a completely redesigned motor bell design with a recessed 6 spoke design, which allows for a lower profile bell and more modern look. The lower profile design has less wind resistance and a lower center of mass, assisting throttle response. On a side note, the recessed spokes also aid massively in the overall durability of the bell itself. This is seriously one tough little motor.

All of these amazing new features and Ethix were still able to keep the weight under 30g - this motor comes in at 29g with the full length of wire and low profile plastic protectors.



Motor Velocity Constant (kV) 1750
Stator Diameter 23mm
Stator Length 6mm
Shaft Diameter 5mm
Weight 29g


Customer Reviews (2)

Light & PowerfulReview by PSAerial
Lighter then my 2507 Brother Hobby Motors on my first Marmotte & little more power... nice and smooth powerband. (Posted on 2/11/2020)
Excellence!Review by Anthony
Best Motors for 6s that I've used yet! Very smooth and very powerful. (Posted on 10/18/2019)

Write Your Own Review

You're reviewing: Ethix Mr Steele Stout Motor V3

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars