2S-6S Charger Interface Panel
2S-6S Charger Interface Panel
Click to zoom in

2S-6S Charger Interface Panel

AC-CIP6E5
Panel-mount board to relocate charger connections

This 2S-6S JST-XH Charger Interface Panel (or CIP) provides a set of balance connectors, an EC5 or XT60 connector, and room for a set of banana plugs (available separately). This product is made to be mounted underneath or on top of many surfaces and panels, such as our ProgressiveRC Case decks, and provides a full relocation of the charger outputs with a full balance board as well as a main charge connector - choose from EC5 or XT60. 

Add a set of banana plugs to the board and you'll be able to use any standard charge cable for any other connector. You can also use this method to connect any parallel boards or cables when charging one battery just isn't enough! 

Installation Note: When using with banana plug posts, ensure both plastic spacers of the banana plug binding posts are above the circuit board - do not use a spacer below the board.

Read More
Read Less

Customer Reviews

Based on 2 reviews
50%
(1)
0%
(0)
50%
(1)
0%
(0)
0%
(0)
T
T.
Poor customer service

The parts I ordered does not fit the top as it should. I was told to drill them myself. I will tell people not to buy your product because you do not stand behind what you sell, nor did anyone offer to make it right for me.

w
w.
EC5 interface

i installed this on a nomad case deck to use with a powerlab 6. works great. switching from battery to battery i only need to put in the charge and balance plug needed for each.
dont forgot that if your going to use this to install into a deck that there is a template "DXF Template for Charger Interface Panel cutout" under the manual tab for this item. that was very helpful for my install.

Customer Reviews

Based on 2 reviews
50%
(1)
0%
(0)
50%
(1)
0%
(0)
0%
(0)
T
T.
Poor customer service

The parts I ordered does not fit the top as it should. I was told to drill them myself. I will tell people not to buy your product because you do not stand behind what you sell, nor did anyone offer to make it right for me.

w
w.
EC5 interface

i installed this on a nomad case deck to use with a powerlab 6. works great. switching from battery to battery i only need to put in the charge and balance plug needed for each.
dont forgot that if your going to use this to install into a deck that there is a template "DXF Template for Charger Interface Panel cutout" under the manual tab for this item. that was very helpful for my install.

Your cart

×